Service - REMOG

Assembly instructions

Installation of knock-on weights

Download knock-on weights installation instruction here.

Select the weight matching the rim shape before installation. Apply the weight to check its fit before installing it to the rim.

Place the weight at the correct spot of the imbalance. Ensure that the clip touches the rim flange before you knock on the weight. The weight‘s body should not touch the rim.

After adjusting the weight correctly, it must be fixed with the proper hammer. Do not use more than two strong hits. Note: Raising the number of hits can damage the weight coating.

To make sure that the weight is attached firmly after the installation, we suggest a second inspection.

Installation of adhesive weights

Download adhesive weights installation instruction here.

Weight, rim and ambience temperatures should be at last 16 °C. In order to avoid grease and silicone residue on the rim clean the rims with a suitable cleaning agent (e.g. isopropanol 70%).

Adjust the adhesive weight to the rim radius with the protective film. The radius of the rim and the weight body must be at least parallel to each other. It is even better if the radius of the weight body is smaller than that of the rim.

After adjusting the weight to the rim radius remove the protective film from the adhesive tape. Before attaching the adhesive tape to the wheel, do not touch it!

Lastly, press the weight against the rim from the centre towards the outer edge. Ensure that the pressure is at least 100 kpa.

Catalogue

Download our REMOG product catalogue here.